American-power-conversion RT Instrukcja Użytkownika Strona 1

990-1289D 03/2006 User Manual EnglishAPC Smart-UPS® RT 3000/5000/6000 VA 200-240 VAC Tower/Rack Mount 3U Uninterruptible Power Supply

8 USER CONFIGURABLE ITEMS NOTE: SETTINGS ARE MADE THROUGH SUPPLIED POWERCHUTE SOFTWARE OPTIONAL SMART SLOT ACCESSORY CARDS OR TERMI

9 NOTE: SETTINGS ARE MADE THROUGH SUPPLIED POWERCHUTE SOFTWARE OPTIONAL SMART SLOT ACCESSORY CARDS OR TERMINAL MODE. FUNCTION F

10 Both Class 2 and SELV circuits must be isolated from all primary circuitry. Do not connect any circuit to the EPO terminal block unless it can be

11 5000/6000 VA models: Terminal Mode is a menu driven interface that enables enhanced configuration of the UPS. Connect the serial cable to the

12 MAINTENANCE AND TRANSPORT Replacing the Battery Module This UPS has an easy to replace, hot-swappable battery module. Replacement is a safe proce

13 REPLACING BATTERY MODULES X Y Z [ \ ] ^ _  Disconnecting the Battery for Transport Always DISCONNECT THE BATTERY(s) before

14 TROUBLESHOOTING, SERVICE, AND WARRANTY INFORMATION Use the table below to solve minor installation and operation problems. Refer to the APC Web s

15 PROBLEM AND POSSIBLE CAUSE SOLUTION BYPASS LED ILLUMINATES The bypass switch has been turned on manually or through an accessory. If bypass

16 Service If the UPS requires service do not return it to the dealer. Follow these steps: 1. Review the problems discussed in the Troubleshooting

17 REGULATORY Regulatory Agency Approvals and Radio Frequency Warnings 200, 208, 220, 230, 240 V MODELS This equipment has been tested and foun

18 Declaration of Conformity

19 APC Worldwide Customer Support Customer support for this or any other APC product is available at no charge in any of the following ways: •

1 Introduction The APC Smart-UPS® RT is a high-performance, uninterruptible power supply (UPS) that provides protection for electronic equipment

2 Wiring and Connecting the UPS 5000/6000 VA XLI MODELS ONLY: HARDWIRING INSTRUCTIONS • Wiring must be performed by a qualified electrician. • In

3 CONNECTING THE BATTERY MODULES AND ATTACHING THE FRONT BEZEL    

4 BASIC CONNECTORS serial com Power management software and interface kits can be used with the UPS. Use only interface kits supplied or approved

5 CONNECTING EQUIPMENT AND POWER TO THE UPS 1. Connect equipment to the UPS (cables not included for XLJ/XLT/XLTW models). 2. Avoid using ext

6 OPERATION Load SMART-UPS RT FRONT DISPLAY Battery Charge Indicator Description Online The Online LED illuminates when the UPS is drawing uti

7 Feature Function Cold Start When there is no utility power and the UPS is off, press and hold the button to power up the UPS and connected e